![]() ![]() I hope some of those clues will help you. I have also tried the version of NetEx that gets installed from the portal, as well as the latest version from mysonicwall. However, the issue is the same when using a "LocalUser" from the sonicwall device. The workstations I am testing from are not domain joined (to the domain doing the LDAP auth). Supply a beginning client IPv4 address in the Client Address Range Beginfield. Under NetExtender Client Address Range, select Use Static Poolfrom the drop down list. Navigate to the NetExtender> Client Settingspage. It is possible the problem is related to Auth scheme.Īnother possibility I haven't been able to test yet, related to the above, is that the reason is related to the computer trying to connect not being a member of the domain. To specify your global NetExtender address range using a Static IP, perform the following steps: 1. This problem seemed to start after enabling LDAP+LocalUsers Auth (was LocalUsers). I thought this might be related to time so I checked the config on the firewall and DC and everything was in perfect sync, so I don't think that is the issue. I would just try and try and eventually it would work. ![]() I have had some seemingly random success. I have had some success with a simple reboot: close NetExtender, Reboot. I wish I had a more complete answer for you, but I have the same problem, and it's not 100% resolved. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |